Monster MP HTFS-IW HC In-Wall PowerCenter for Custom Installations

for 15 amp circuits * 50-amp peak current capacity * 2 surge-protected AC outlets * 2 custom face plates, plus blank face plate * status indicators and audible alarm *

Obviously I don't know if the surge protection part of this thing works yet, but as far as looks, it's done the trick. It hid all my cords behind my flat panel very nicely and as long as the built in surge does it's job, I'll be more than happy with this purchase. If my TV gets killed in a storm though, I'll make sure to update this review. LOL!

good from what I can see but wish the power was recessed to hide that more like other products. Its also a little expensive but hope that saves the LCD in cases of surges.

I needed a power surge protector that would fit behind my LCD wall mounted television set. There is only about 1.5 inches clearance between the wall and the television set and I didn't want any exposed wires. This device is not available in any stores (Home Depot/ Fry's Electronics/ 2 different electrical supply stores etc) but I found just what I needed on Amazon! It works great. It took about two hours to install but I am a homeowner, not a contractor. Could probably do the 2nd one in 30 minutes now that I know what I am doing.

I am very pleased by the quality of this product. It gives a very clean look to my 52" LCD TV wall mount installation.

Very well designed product. Great idea with one module with nylon fibers to help run, and make cables more attractive coming through wall. Flat receptable plug in for behind t.v. is a great idea, but the other end would not fit in my Panasonic with the bump out on the end. Contacted Monster cable on their web page,and asked them for information if they had any that would fit into my Panasonic, and they did not respond. Over satisfied, but not happy with their customer service not responding.